How To Clean A Toshiba Laptop A215

This teardown is non a repair guide. To repair your Toshiba Satellite A215, use our service manual.

• Remove the battery







• Loosen this spiral, and pop out the RAM embrace.

• Undo the module clamps, gently elevator the finish of the module to a 45-caste angle and pull it out. Do the same for the one below.

• Make sure not to betrayal the retentivity to any static electricity whatever, ground yourself before handling it past either touching an unpainted metallic surface or wearing an anti-static bracelet.

• Loosen these iii screws, and pop out the two difficult drive bay covers

• Pull out the plastic tab located here, and pull it gently only firmly to the correct.

• Remove this screw, it might crave tweezers after loosening to become out.

• Insert a paper clip into this hole, which will pop out the bulldoze

• Grasp the drive tray and gently but firmly pull information technology out of the laptop chassis.

• Remove these screws

• Flip the laptop over, and push the bezel towards the lcd while lifting up, this might crave some force.

• Remove the two screws at the top of the keyboard

• Guide the keyboard towards the LCD, and elevator up slightly, exist careful of the ribbon cable underneath

• Using a spudger or fingernail, carefully push one side, and then the other of the keyboard ribbon connector toward the LCD, releasing information technology.

• Remove the 2 screws on the bottom of the laptop

• Flip the laptop over

• Disconnect the LCD cable and thread it out of its path and then it's free

• Using a spudger or fingernail popular off the 2 wifi antennas and thread them out too

• Remove the four screws on the LCD hinges

• Elevator the brandish panel up and out

• Remove this screw from the top of the laptop

• Remove these 12 screws from the lesser of the laptop

• Carefully, using a spudger or fingernail, release the touchpad ribbon cable from its connector.

• Run your fingernail or spudger along the cleft betwixt the acme bezel and bottom casing at the dorsum of the laptop, and continue to release the clips and lift off the bezel.

• Remove this spiral

• Okay, don't freak out, only at that place are a Bunch of clips and connectors to disengage at this indicate, but keep calm and know where your towel is and all will be well.

• Disconnect, using a spudger or fingernail, the following connectors:

• USB header

• Speakers

• Power/media buttons

• VGA connector and screw

• Fan ability

• Modem connector (lift upwardly tape)

• Pare back the metal record from the fan

• Lift the fan up and abroad from the vent

• Tough part: Lift the motherboard at the rop right corner, discover this cable underneath and gently jerk information technology out.

• Lift the lath out, pin it slightly to let the sound connectors to come gratis, then simply lift.

• Remove these four screws, and slide the bracket off

• Carefully lift upwards the heatsink

• Using a flathead, turn this to release the processor

• Be conscientious when handling processors, the same precautions as memory should be taken.

• Phew! Hither we go, guts and all. Give yourself a pat on the back, and follow these instructions in opposite to reassemble.

Embed this guide

Cull a size and re-create the lawmaking below to embed this guide every bit a small widget on your site / forum.

Preview

Source: https://www.ifixit.com/Teardown/Toshiba+Satellite+A215+Teardown/7598

Posted by: millerworach1958.blogspot.com

Share this post